The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

форумы  помощь  поиск  регистрация  вход/выход  слежка  RSS
"Нет voice-port на Cisco 7206VXR"
Вариант для распечатки  
Пред. тема | След. тема 
Форум Маршрутизаторы CISCO и др. оборудование. (Сопряжение с АТС)
Изначальное сообщение [ Отслеживать ]

"Нет voice-port на Cisco 7206VXR"  +/
Сообщение от DanilKT (ok) on 20-Окт-16, 11:27 
Добрый день! Прошу помощи!
Имеется Cisco 7206VXR, модуль PC-MA-8TE1+.Пытаюсь настроить подключение к провайдеру по Е1. Физическая линия поднимается, сериальные интерфейсы создаются. Но команды voice-port просто нет. И show voice port summary ничего не показывает. Может не хватает каких-то модулей? Или версия IOS не та? Или что-то не дописал в конфиг?

Router#sh version
Cisco IOS Software, 7200 Software (C7200-ADVENTERPRISEK9-M), Version 12.4(24)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Thu 26-Feb-09 00:31 by prod_rel_team

ROM: System Bootstrap, Version 12.3(4r)T3, RELEASE SOFTWARE (fc1)
BOOTLDR: Cisco IOS Software, 7200 Software (C7200-KBOOT-M), Version 12.4(12b), RELEASE SOFTWARE (fc2)

Router uptime is 13 hours, 12 minutes
System returned to ROM by reload at 21:23:28 MSK Wed Oct 19 2016
System restarted at 21:26:33 MSK Wed Oct 19 2016
System image file is "disk2:c7200-adventerprisek9-mz.124-24.T.bin"
Last reload reason: Reload Command

Cisco 7206VXR (NPE-G1) processor (revision C) with 983040K/65536K bytes of memory.
Processor board ID 34188278
SB-1 CPU at 700MHz, Implementation 1025, Rev 0.2, 512KB L2 Cache
6 slot VXR midplane, Version 2.9

Last reset from power-on

PCI bus mb1 (Slots 1, 3 and 5) has a capacity of 600 bandwidth points.
Current configuration on bus mb1 has a total of 0 bandwidth points.
This configuration is within the PCI bus capacity and is supported.

PCI bus mb2 (Slots 2, 4 and 6) has a capacity of 600 bandwidth points.
Current configuration on bus mb2 has a total of 0 bandwidth points.
This configuration is within the PCI bus capacity and is supported.

3 Gigabit Ethernet interfaces
66 Serial interfaces
8 Channelized/Clear E1/PRI ports
509K bytes of NVRAM.

127488K bytes of ATA PCMCIA card at slot 2 (Sector size 512 bytes).
16384K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102

Router#show inventory
NAME: "Chassis", DESCR: "Cisco 7206VXR, 6-slot chassis"
PID: CISCO7206VXR      , VID:    , SN: 34188278

NAME: "NPE-G1 0", DESCR: "Cisco 7200 Series Network Processing Engine NPE-G1"
PID: NPE-G1            , VID: V03 , SN: 36338871

NAME: "disk2", DESCR: "128MB Compact Flash Disk for NPE-G1"
PID: MEM-NPE-G1-FLD128 , VID:    , SN:

NAME: "module 1", DESCR: "8 port, software configurable Multichannel T1/E1 without TDM Port Adapter"
PID: PA-MC-8TE1+         , VID:    , SN: JAE09044MKR

NAME: "Power Supply 2", DESCR: "Cisco 7200 AC Power Supply"
PID: PWR-7200-AC       , VID:    , SN:

Router#show controllers e1
E1 1/0 is up.
  Applique type is Channelized E1 - balanced
  No alarms detected.
  alarm-trigger is not set
  Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.
  International Bit: 1, National Bits: 11111
  Linestate Debounce is disabled
  Data in current interval (749 seconds elapsed):
     0 Line Code Violations, 0 Path Code Violations
     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
  Total Data (last 50 15 minute intervals):
     0 Line Code Violations, 0 Path Code Violations,
     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
E1 1/1 is up.
  Applique type is Channelized E1 - balanced
  No alarms detected.
  alarm-trigger is not set
  Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.
  International Bit: 1, National Bits: 11111
  Linestate Debounce is disabled
  Data in current interval (750 seconds elapsed):
     0 Line Code Violations, 0 Path Code Violations
     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
  Total Data (last 52 15 minute intervals):
     0 Line Code Violations, 0 Path Code Violations,
     0 Slip Secs, 1 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
     1 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
E1 1/2 is administratively down.
E1 1/3 is administratively down.
E1 1/4 is administratively down.
E1 1/5 is administratively down.
E1 1/6 is administratively down.
E1 1/7 is administratively down.

Router#show interfaces serial 1/0:15
Serial1/0:15 is up, line protocol is up (spoofing)
  Hardware is PA-MC-8TE1 Plus
  MTU 1500 bytes, BW 64 Kbit/sec, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation HDLC, crc 16, loopback not set
  Last input 00:00:06, output 00:00:06, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: weighted fair
  Output queue: 0/1000/64/0 (size/max total/threshold/drops)
     Conversations  0/1/16 (active/max active/max total)
     Reserved Conversations 0/0 (allocated/max allocated)
     Available Bandwidth 48 kilobits/sec
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     8835 packets input, 35235 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     8830 packets output, 35199 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 unknown protocol drops
     0 unknown protocol drops
     0 output buffer failures, 0 output buffers swapped out
     1 carrier transitions   no alarm present
  Timeslot(s) Used:16, subrate: 64Kb/s, transmit delay is 0 flags

Router#show voice port summary
                                           IN       OUT
PORT            CH   SIG-TYPE   ADMIN OPER STATUS   STATUS   EC
=============== == ============ ===== ==== ======== ======== ==

PWR FAILOVER PORT        PSTN FAILOVER PORT
=================        ==================

Ответить | Правка | Cообщить модератору

Оглавление

Сообщения по теме [Сортировка по времени | RSS]


1. "Нет voice-port на Cisco 7206VXR"  +/
Сообщение от mid0ri on 21-Окт-16, 14:01 
Видимо, вам не хватает PA-VX* Voice Port Adaptors.
http://www.ebay.com/itm/Cisco-PA-VXB-2TE1-Digital-Voice-Port...

Ответить | Правка | ^ к родителю #0 | Наверх | Cообщить модератору

2. "Нет voice-port на Cisco 7206VXR"  +/
Сообщение от fantom (??) on 27-Окт-16, 06:24 
Если память мне не изменяет, то PC-MA-8TE1+  - только для данных...

>[оверквотинг удален]
>            
>          IN  
>      OUT
> PORT            
> CH   SIG-TYPE   ADMIN OPER STATUS  
> STATUS   EC
> =============== == ============ ===== ==== ======== ======== ==
> PWR FAILOVER PORT        PSTN FAILOVER
> PORT
> =================        ==================

Ответить | Правка | ^ к родителю #0 | Наверх | Cообщить модератору

Архив | Удалить

Рекомендовать для помещения в FAQ | Индекс форумов | Темы | Пред. тема | След. тема




Партнёры:
PostgresPro
Inferno Solutions
Hosting by Hoster.ru
Хостинг:

Закладки на сайте
Проследить за страницей
Created 1996-2024 by Maxim Chirkov
Добавить, Поддержать, Вебмастеру